Відео

Hi Gents i don't understand what is reset factor of GEN. & why is consider 0.95 ?

Basics well explained using good hand sketches and good English communication. Thank you.

Sir in definition you are saying pick up current as 120% of full load current however in calculation you are dividing it by CT ratio. I guess definition should be corrected. Similarly for PSM.

Very much useful sir❤ I HAVE WATCHED ALL YOUR VIDEOS,TOO IMPORTANT FOR INTERVIEWS

Good video, thankyou.

What about the harmonics ?

If I only know primary voltage and secondary voltage and secondary amperes how do I find primary amperage

Why the angle between the vref and the flux v is not 90 degrees, i have seen many text that stated that, by the way thank you very much for the content i am studying this at my university and i am a little bit struggling haha

Nice explanation

0.859 sq.inch=554sq.mm, provided Busbar 1000sq.mm>554sq.mm; Hence 1000sq.mm is more than the required minimum size busbar.

Hi I believe in both the fault conditions NCT sec. Current direction direction will be same. Your considering two different directions for outside and inside faults. Could you please correct me if I am wrong

Great effort friend

Great one small explanation but all thing include

Aptly explained. Hope this the tutorial will aid students as well as beginners of profession a handy presentation. Thanks a lot.

Long time

It was really informative video. Please can you provide a clear view regarding Io and I1' both are same and if they are not, then Is Io will be considered as no load current or I1'?

amazing video.

Hi. Are you sure about your explanation for close the disconnector???? 9:00 to 10:00 You can not close the disconnector just because the voltage of both side is equal.

Thank you sir,so much helpful🙏🙏,Plz Upload new video☑️

Thank you sir,very informative video🙏🙏,Plz Upload new video☑️

Thank you sir,so much helpful🙏🙏,Plz Upload new video☑️

How to calculate generator or transformer earth fault current which one we are limiting through NGR.

can someone pls share link to part 2 of this video

When outside fault are occurring near light why mcb are phase 50ka fault current..

Need video on ferroresonence resistor

Can you please add some ups sizing contents for NiCd/Lead acid .

Good and informative lessons

Thanks Sir

Nice explanation

Like your information videos ,pls suggest suitable numerical book on protection for experienced industrial professionals

Nice & helpful video

Best

How calculate VA of PT. Pls make a vedio

Sir, as I know, transformers do not contribute or feed fault current in the system, might be i am wrong.

confusing concept 😮😮😮

what's logic of 58 percent and 33 percent settings. clarify

Love it

Nice lecture👍👍

Can you please further explain what is this 7% of reactor and why do we consider this.

Bro which software are you using for explaining this ?

Hindi me Explain karne me Tx Dena padta kya aap ko....

it is superb video .could you explain me the difference between fixed KVAR and virable KVAR please?

Quite illustrative. Excellent,

❤🇧🇩

I need your session. How do i contact you?

Need differential relay settings

explain very nice

Excellent